HPE Community
ProLiant Servers (ML,DL,SL)
1752810 Members
5725 Online
108789 Solutions
New Discussion

Re: ML350p Gen8 - Adding a SAS Expander

 
Stubbsy
Occasional Contributor

‎03-16-2016 01:01 PM - edited ‎03-16-2016 01:03 PM

‎03-16-2016 01:01 PM - edited ‎03-16-2016 01:03 PM

ML350p Gen8 - Adding a SAS Expander

Hi I attempted to added an addioanal SAS Expader to an production ML350P G8 server . I wired it up to the the P420 controller however upon boot, only the first 4 orginal drives were detected in the orginal bay. Drives 567and8 were not!  nether did the dirives work in the new expander. I wired it back as it was and the the origainal drives work again. Any idears. I was thinking firmware upgrade first, but would like to see if anyone has any other idears as its is a production server so need to mimimise downtime.  I have attaced a photo of how I wired it up. The original bay is on the left and the expander is on right of the photo

0 Kudos
Reply
2 REPLIES 2
ZyZ74
New Member

‎10-24-2016 02:01 AM

‎10-24-2016 02:01 AM

Re: ML350p Gen8 - Adding a SAS Expander

Hi, did you solve the problem? I have the same problem that you had. Any suggestions how to solve it?

 

Best regards 

 

Stefan

0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎10-24-2016 07:05 AM

‎10-24-2016 07:05 AM

Re: ML350p Gen8 - Adding a SAS Expander

all firmware up to date?

 

http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c04278751

 


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.