HPE Community
ProLiant Servers (ML,DL,SL)
1752610 Members
4053 Online
108788 Solutions
New Discussion

Partition size error 0 MB on DL 360 Gen 9

 
Michael Ridenour
Occasional Visitor

‎04-11-2018 09:21 AM

‎04-11-2018 09:21 AM

Re: Partition size error 0 MB on DL 360 Gen 9

April 2018 and the issue still exists, at least it does on a DL20 Gen 9 manufactured in Sept 2017. The solution offered by LogicalStep to go back the the raid configuration and select the array to be the boot drive is what worked for me.  With this being a known issue for three years one would think that it should be fixed by now.

0 Kudos
Reply
UnhappyDoug
Frequent Visitor

‎08-24-2018 11:53 AM - last edited on ‎08-27-2018 12:02 AM by

‎08-24-2018 11:53 AM - last edited on ‎08-27-2018 12:02 AM by

Re: Partition size error 0 MB on DL 360 Gen 9

seriously! cannot believe this cr*p ins't sorted! Just installing a DL360Gen10 and there is no where to adjust to partition size?! AND no software installed when using IP!! Borked up the IP when I tried to flash it using the built in f/w update! What a waste of space this rubbish is! Wasting my whole Friday evening. Ended up following suggestion above of creating smaller logical drive in SSA, then expanding from within windows later. thinking of moving to Dell

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.