- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Proliant ML350p Gen8 - problems with acu and bay m...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-06-2019 03:10 PM
03-06-2019 03:10 PM
Proliant ML350p Gen8 - problems with acu and bay mapping
Hi,
i have an proliant server with 16 hdds. in acu I see for hdd, bay 1, 2, 3, 4, 13, 14, 15, 16.
The rests all mapped to bay 0.
the correct and not correct bays are mixed with port 1 + 2. Array ist P420i.
Firmware is just installed to last verion. OS is windows 2012 R2.
Somebody an idea, while bay mapping is not correct?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2019 01:06 AM
03-13-2019 01:06 AM
Re: Proliant ML350p Gen8 - problems with acu and bay mapping
Hi,
Good day,
Since when you obseved this issue ?
Hope you have the correct part installed in the server.
Please have them verified again (backplane, backplane power cables) also ensure that cables are not damage.
Update backplane firmware to latest.
if issue persist please raise a case with HPE support for further investigation.
Regards,
Sudhir
>