- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Re: RAID 1 rebuild stuck on 0%
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-01-2016 06:45 PM - edited 05-01-2016 06:47 PM
05-01-2016 06:45 PM - edited 05-01-2016 06:47 PM
RAID 1 rebuild stuck on 0%
Hi,
One of my clients has an old HP Proliant ML150 G6 1.0 with a B110i raid controller .
All weekend the server was down and this morning the office manager restarted the server and selected F1 to start a rebuild because there was some error about the raid-1 consistency.
Now when I access the Smart Array B110i SATA RAID Controller on System Board via HP System Management, it shows an exclamation mark on Logical Drive 1 - Mirroring (RAID 1) and states the following:
Percent Rebuild Complete: 0% and this percentage is not growing at all. Looks as if it is stuck there.
All the drives are OK with green check marks
My question is: Why does it need a rebuild if the drives show OK? I have not replaced any drives.
Have a look at the attached image.
Thanks and regards
Alfred56
Thanks and
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-08-2019 03:30 AM
04-08-2019 03:30 AM
Re: RAID 1 rebuild stuck on 0%
Where it end up with ??
Shall i Wait ???