HPE Community
ProLiant Servers - Netservers
1752797 Members
5965 Online
108789 Solutions
New Discussion

HP proliant microserver g7 RAID 1 hard disk change

 
fernandogomez
New Member

‎08-13-2014 05:01 AM

‎08-13-2014 05:01 AM

HP proliant microserver g7 RAID 1 hard disk change

Hello all,

 

We buy one HP proliant microserver G7 and we configure it with two ssd in RAID1. I shut down HP and disconnect one disk, then I power on HP again and send me advertisement, critical RAID1 this is OK, so I shut down HP again and reconnect disk again, and I see critical RAID1. So how can I reconnect it and made mirror?

 

Thanks!

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎08-13-2014 05:29 AM

‎08-13-2014 05:29 AM

Re: HP proliant microserver g7 RAID 1 hard disk change

You cannot mirror a spinning disk and a non spinning disk.

 

Take a backup and restore it.

 

There never was a G7 microserver, only a first generation and a Gen8.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Jimmy Vance
HPE Pro

‎08-13-2014 06:03 AM

‎08-13-2014 06:03 AM

Re: HP proliant microserver g7 RAID 1 hard disk change

I have the same mindset Torsten, but somewhere along the way the original MicroServer offereing was rebranded as a MicroServer G7.

 

As for the original question, you need to use the raid utility at boot time to kick off the mirror process when you replace a disk

No support by private messages. Please ask the forum! 
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.