ProLiant Servers - Netservers
cancel
Showing results for 
Search instead for 
Did you mean: 

ML110 G5 and RAID1: How to tell when a hdd fails?

 
Highlighted
Occasional Advisor

ML110 G5 and RAID1: How to tell when a hdd fails?

I've a ML110 G5 set up with two HDDs in RAID1 on the built-in SATA RAID controller. In the event of a hdd failure, how would I be notified? I don't have any application for RAID management installed (Windows Server 2003). How would I know which hdd has failed?
2 REPLIES 2
Highlighted
Frequent Advisor

Re: ML110 G5 and RAID1: How to tell when a hdd fails?

Check in the ARRAY CARD BIOS/ROM, you will have all info there.

PS. if the RAID 1 is damaged the beeper should beep ;)
When you are giving points It's like saying Thank You :-)
Highlighted
Advisor

Re: ML110 G5 and RAID1: How to tell when a hdd fails?

I've got 2 setup. Go to the support / drivers page and install the management software / service. It can be set to send you an email when faults arise.