ML350 G1 - RAID LC2 Controller - Fan Error

[BR733395]

System Management Homepage reports that the fan of a RAID LC2 Controller is failed

Which fan ? There is no fan on a LC2 controller
The server (ML350-G1) has 2 system fans and they're working fine

thx
Filip





Report Array Diagnostic :

Array Diagnostic Utility Version 7.30.6.0
Array Diagnostic Utility Inspection Report Version 7.30.5.0

Date/Time: Monday, June 20, 2005 5:17:55PM
Computer Model: HP Server


SLOT SUMMARY:
Slot Num Slot Type Array Controllers and Host Adapters Detected
-------- --------- --------------------------------------------
SLOT 6 PCI RAID LC2 Controller

SLOT 6 RAID LC2 Controller ERROR REPORT:

Storage enclosure on SCSI bus 1 indicated that the fan failed.
SOLUTION: Replace the fan.

SUBSYSTEM INFORMATION:

Chassis Serial Num: Not Available
This Controller
Array Serial Number: P375B0EBFKYQO2
Cache Serial Number: Not Available
Other Controller
Array Serial Number: Not Available
Cache Serial Number: Not Available

CONTROLLER IDENTIFICATION:
Configured Logical Drives: 1
Configuration Signature: 0xa06002e0
Controller Firmware Rev: 1.06
Controller ROM Revision: 1.06
Controller Hardware Rev: 0x02
Boot Block Version: 1.06
Board ID: 0x40480e11
Cable or Config Error: 0x00 (No)
Invalid Host RAM Address: No
CPU Revision: 0x00
CPU to PCI ASIC Rev: 0x00
Cache Controller ASIC Rev: 0x00
PCI to Host ASIC Rev: 0x00
Marketing Revision: 0x41 (Rev A)
Expand Disable Code: 0x01
SCSI Chip Count: 1
Max SCSI IDs per Bus: 16
Big Drive Map: 0x0007 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000
Big Ext Drive Map: 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000
Big Non-Disk Drive Map: 0x0080 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000
Fibre Chip Count: 0
Recovery ROM Inactive
Image Revision:
Recovery ROM Active Image
Flags Status: 0x00