Netserver E800 no boot after power out

[CA850077 · Accepted solution]

Sorry about the bad news.

If you feel I was helpful could you please give me a some points. Here some guidelines on that.

http://forums1.itrc.hp.com/service/forums/helptips.do?#28


Thanks,

Andrew Balliet

P.S. The currently HP server that is the same class as the E800 is the tc2120.

[jtreyes]

I had the same problem. After checking the Phoenix support site, I installed a new video card and the system booted with no problems.

"...The only AwardBIOS beep code indicates that a video error has occurred and the BIOS cannot initialize the video screen to display any additional information. This beep code consists of a single long beep followed by two short beeps. Any other beeps are probably a RAM (Random Access Memory) problems..."

May not be the right BIOS, but it worked.