HPE Community
Operating System - HP-UX
1751709 Members
4941 Online
108781 Solutions
New Discussion

Who Me Too'd this topic

Eric SAUBIGNAC
Honored Contributor

‎04-13-2010 12:07 AM

‎04-13-2010 12:07 AM

Question about unsupported HP-UX 11.11 vgmodify command

Hi guys,

never used vgmodify on HP-UX 11.11. Does it work the same as with HP-UX 11iv2 or 11iv3 and 1.0 LVM Volume Groups ?

In fact, I just got the vgmodify from HP Support. But with no documentation. I am supposed to increase the size of some SAN LUN by 5 Go each, and VG parameters are all OK to acknowledge the increased size.

Under 11iv2 or 11iv3 I would just have to do a vgmodify with no parameter on the inactive VG to see the new size in the VG. Does it work the very same on 11.11 for this very specific use ?

Thanks in advance for your very, very, fast answer : I am supposed to do it in less than 2 hours ...

Eric
1 person had this problem.
0 Kudos
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.