HPE Community
BladeSystem - General
1752579 Members
3129 Online
108788 Solutions
New Discussion

Who Me Too'd this topic

ilay23
Occasional Advisor

‎10-06-2011 08:00 AM

‎10-06-2011 08:00 AM

server vlan tagging with SUS with map mode

hi all

i have a c7000 enclosure and flex-10 virtual connect on the vc i want to create 3 vnet where all of them will go through the same uplink so i have SUS and on the blade server i will install Vmware where i will create vlans but each of the server nic will be connected to only one vlan

 

so and as i understood from some hp readings i cannot use tunnel mode with SUS as vlan tags will be added on the server itself am i wrong?

 

but on the other side 

on the vc user guide the following note is mentioned

"If you are deploying a server where VLAN tags will be used (added) on theserver itself, do not connect the server Ethernet port carrying VLAN-tagged traffic to a shareduplink set."

 

so how to solve this problem?

1 person had this problem.
0 Kudos
Reply
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.