HPE Community
HPE EVA Storage
1753797 Members
7199 Online
108805 Solutions
New Discussion

Who Me Too'd this topic

Andrew DeVries
Occasional Advisor

‎10-31-2011 09:00 AM

‎10-31-2011 09:00 AM

MSA 1000 Console Cable HP 259992-01

I bought a used MSA 1000 Console and went through the procedure to reset the passwords of the Fiber Switches, and am now tring to configure the arrays and Lun using the CLI.  I purchased a new cable, it is labeled HP 259992-01. I fi connect to the console at 19200, 8, none, 1 no flow control. I see the switch post and updates on batery status as they charge etc. I have pressed Enter repeatly but can't get a CLI prompt.  I am suspecting  a bad console cable. I am using hyperterminal and have also tried putty. I know my serial port works and even tried a different computer as serial port with the same result.

 

Any Suggestions?

 

 Can some one check the pinout on there cable and make sure it matches below?

 

The pinout of my cable is as follows.

 

9-pin                rj45Z
2                      2
3                      9
5                      5,6
8                      5,6
9                      5,6

 

 

 

Andy

1 person had this problem.
0 Kudos
Reply
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.