HPE Community
Switches, Hubs, and Modems
1752567 Members
5217 Online
108788 Solutions
New Discussion

Who Me Too'd this topic

amesc
Occasional Visitor

‎02-22-2012 07:47 AM

‎02-22-2012 07:47 AM

HP NJ2000 - PoE clients not receiving power when connected to a CISCO 2960S

I have a 3Com knowledbase article, relating to PoE not being made available on ports 1 or 2 on a NJ2000 when the NJ2000 is connected to a Cisco 2960S switch, which delivers PoE+/802.3at

Is this still the situation? I have a NJ2000 upgraded to v2.00.07 software, which according to the release notes, 2.0.5 made the device compatible with more PoE switches. This reports power input is 802.3af only and the Cisco switch has been configured to run LLDP and power management related LLDP TLVs are switched off as a result of searching around and finding a support document titled "HP E-Series switches with POE+ ports do not provide PoE+ 802.3at power to Intellijack NJ2000(JD057A) by default."

2 people had this problem.
0 Kudos
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.