HPE Community
IMC
1753519 Members
4839 Online
108795 Solutions
New Discussion

Who Me Too'd this topic

Svenskjen
Occasional Contributor

‎04-01-2014 04:19 AM

‎04-01-2014 04:19 AM

NTA - Sflow only show inbound traffic

I am trying to understand sflow configuration and traffic analysis tasks. I have configured a 2920 switch to send sflow data to my IMC. TI created a device in IMC that includes all interfaces on the switch. I assume that the device/switch will send all interface data to imc and that I will have the possibility to create analysis tasks of individual interfaces. 

I have tried manual sflow config through CLI and snmp-based config through IMC. Both ways, I only see inbound traffic. 

I am probably missing something fundamental but simple.

2 people had this problem.
0 Kudos
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.