HPE Community
Software Defined Networking
1751848 Members
5035 Online
108782 Solutions
New Discussion

Who Me Too'd this topic

WeLi
Occasional Visitor

‎05-17-2015 08:29 PM - edited ‎05-17-2015 08:47 PM

‎05-17-2015 08:29 PM - edited ‎05-17-2015 08:47 PM

Can't see the End node & Link in OpenFlow Topology

I can't see the node and link in OpenFlow Topology when i add two PC to OpenFlow Switch, and ping PC A to B through a OpenFlow instance(that ping is success).

 

My Hardware & Software information :

 

OpenFlow Switch : HP 5130 EI Switch     Firmware : Version 7.1.045, Release 3106

 

Controller : VAN Controller Version 2.4.6.0627 & Ubuntu 12.04.5

 

OpenFlow Negotiated Version : 1.3

 

--------------------------------------------------

 

In other way,it can display the node and link when i tried use Mininet to deploy the topology.

 

OpenFlow Negotiated Version : 1.0

 

MIninet vSwitch version : 1.4.6

 

I can controller the instance flow but just can't see the topology, I don't know where the configure is wrong.

 

1 person had this problem.
0 Kudos
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.