- Community Home
- >
- Software
- >
- HPE OneView
- >
- Who Me Too'd this topic
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
Who Me Too'd this topic
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-24-2015 08:50 AM
07-24-2015 08:50 AM
Can't create server profile
I'm trying to add a profile to some of my DL380 Gen 8's and Oneview will reboot the server into intelligent provisioning but after about 8 minutes it will fail with the following error "An unexpected problem occurred while mounting iLO virtual media. Intelligent Provisioning failed to mount the iLO virtual media"
For some reason it is unable to mount the firmware ISO during the profile setup. I'm assuming it's some kind of network issue trying to mount the ISO but I'm not sure if there are any logs that I could be looking at. I can manually mount the SPP iso through ILO and install it but when oneview tries to it fails.
The version of oneview I'm running is 1.20.05-0201918, Jun 2, 2015. I'm trying to use the 2015-04-0 SPP and the DL380 is running Intelligent provisioning 1.62.
I feel like if I knew the path that oneview is trying to use to mount the ISO I could troubleshoot it.