HPE Community
Comware Based
1753511 Members
4839 Online
108795 Solutions
New Discussion

Who Me Too'd this topic

Dinesh4
Occasional Advisor

‎10-04-2018 12:20 AM

‎10-04-2018 12:20 AM

How to make redirection work for HP5130 switch

Hi Experts,

We are in the middle of deploying Cisco's NAC solution in our wired environment. There is use-case where in of a user does not have a posture module, then that user would be redicrected NAC solution to download the module, and then will be postured and allowed further network access.

Now what is happening is that, we are not able to get the redirection to work with the HP5130 model of switches. Even when we can see that NAC is sending the redirection URL, but the switch is somehow not able to interpret and apply it for the connected use session.

While I was looking for some documentation, there was this one documentation that talks about integrating 5130 with Clearpass, where we need to have these two additional attributes, attributes #210, H3C-AVPair and attribute #250, H3C-Web-URL.

When I use any one of these attributes, I do not see any URL being pushed from the NAC, but if I use attribute HPE-Captive-Portal-URL, I see that the URL is being pushed fine, but the switch is not able intepret it.

So has anyone got this working earlier?
Is redirection supported for those model of switches?

Attached are screenshots where you can see what URL are being pushed.

Any pointers are much appreciated!

1 person had this problem.
0 Kudos
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.