HPE Community
ProLiant Servers - Netservers
1752606 Members
4935 Online
108788 Solutions
New Discussion

Who Me Too'd this topic

lwsamcn
Occasional Contributor

‎05-03-2019 10:01 AM - edited ‎05-03-2019 10:40 AM

‎05-03-2019 10:01 AM - edited ‎05-03-2019 10:40 AM

No Graphic signal output when install Role as AD and promo to DC

Hello, somebody can help me.

 

gen10 installed w2012r2. it goes well. MS office and Teamviewer is runing fine on the server.

Then  I added a role as AD and promo to DC. it shows all going well.

system hint restart. after it restart. NO Graphic signal output. 

I  can see it on line on Teamviewer from remote computer.

i try to establish session by teamviewer. but password is not long valid.

Force restart, BIOS is runing  fine. and cound not find any error.

when press boot for windows. it displays nothing  on monitor. Monitor show no signal.

what did I lose for  configuration or wrong setup during DCPROMO?

I am afraid of that even I reinstall OS. the problem still come if the cause not get.

tks n brgds

Liu Wei

 

 

1 person had this problem.
0 Kudos
Reply
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.