HPE Community
ProLiant Servers - Netservers
1753831 Members
9550 Online
108806 Solutions
New Discussion

Who Me Too'd this topic

Szabi
Occasional Contributor

‎04-19-2020 04:01 AM - edited ‎04-19-2020 04:02 AM

‎04-19-2020 04:01 AM - edited ‎04-19-2020 04:02 AM

HP Microserver Gen8 Nand problem

So I got this week a second hand HP Microserver Gen8 what had been used for home nas for a couple of years. Nothing on server was upgraded so I upgraded everything what I could to the latest version.

iLO Diagnostics states:

Controller firmware revision 2.10.00 NAND read failure: Media is in a WRITE-PROTECTED state 

and an exclamation mark with the message:

ProLiant MicroServer Gen8 System Programmable Logic Device version 0x06 

 

Now, i tried everything what i found about this problem, my gut tells me that it`s a faulty motherboard. Howewer one interesting thing found out was, if i downgrade iLO to version 2.54 and perform a NAND format with the server off, the whole Diagnostics page goes green, state of NAND becomes OK. Untill i boot up the server. Than it changes again back to "Failed restart/Initialising media" state.

Is there anything i can do? How can i configure a new Array without the HP Smart Array Assistant or Inteligent Provisioning? Is it safe to use this way the server?

Thank you in advance,

1 person had this problem.
0 Kudos
Reply
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.