Servers and Operating Systems
Have questions about servers and operating systems? Find information, share knowledge, and discuss solutions with these HPE Community blogs and forums.
1856496
Members
16744
Online
104113
Solutions
Latest Articles and Discussions
How To find ERROR :Please enter valid Opportunity Id using correc ...
Posted to: Servers - General
03-31-2026 ErrorERROR Please enter valid Opportunity Id using correct format OPE 10 digits with no extra space
0
Kudos
252
Views
1
Reply
Advice needed for HPE Synergy / OneView upgrade path from 9.40 to ...
Posted to: HPE Synergy
03-30-2026 Hello everyone,I would appreciate your advice regarding the upgrade of my Synergy chassis.My HPE Synergy chassis are currently running OneView 9.40, with firmware from HPE Synergy Service Pack SY ...
0
Kudos
3417
Views
3
Replies
saupdate.efi to fs Drive
Posted to: Integrity Servers
03-30-2026 Hello EveryoneThis is 555-Denoh。My new clients do not use USB memory sticks.I was using an rx2800i6 and, after replacing the system board, I changed the P410i's mode from RAID to HBA using saupda ...
0
Kudos
925
Views
5
Replies
Secure Boot certificates - ROM or ILO?
Posted to: HPE ProLiant Servers (ML,DL,SL)
03-30-2026 Hi all,In June 2026, the certificates of the certification authorities used in UEFI Secure Boot will expire.Does HPE have any information on this? I can't find anything very specific. My que ...
0
Kudos
394
Views
2
Replies
Heatzink model for cpu 6100 and 6200
Posted to: HPE ProLiant Servers (ML,DL,SL)
03-30-2026 Hi forum I have replaced some 6100 cpu's with 6242 cpu on my DL 380 G10 servers.I have reused the heatzink that was in server with original 6100 cpu.Is that ok or does 6242 need another heat ...
0
Kudos
1854
Views
3
Replies
282 - Invalid Server Serial Number and Product ID
Posted to: HPE ProLiant Servers (ML,DL,SL)
03-29-2026 Dear allGreetings!!!Yesterday i am facing a issue while upgradation SPP version in DL 380 Gen11Steps what i am taken mentioned below.Step -1 Cross check Serial no and product is available or not ...
0
Kudos
290
Views
2
Replies
