- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - Linux
- >
- Re: How to configure standby heartbeat network on ...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2019 03:30 AM
07-13-2019 03:30 AM
How to configure standby heartbeat network on hp ux serviceguard
In my enviroment i have two node hp ux-v3 serviceguard, for heartbeat network we have configure single NIC from both node, i want to confgiure another physical NIC for standby heartbeat network.
Note: link aggregation is not possible due to 10G nic, confirm by HPE back line team.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-18-2019 09:30 PM
07-18-2019 09:30 PM
Re: How to configure standby heartbeat network on hp ux serviceguard
Examine the cluster configuration ASCII file , sometimes
called /etc/cmcluster/cmclconfig.ascii or better create a new config file using current settings using cmgetconf command. You might have some
STATIONARY_IP exists, change it to HEARTBEAT_IP and cmcheckconf and cmapplyconf.
or
if you have extra interface, create entry below each hosts as:
NETWORK_INTERFACE lanx
HEARTBEAT_IP xx.xx.xx.xx
and check and apply the config.