StoreEver Tape Storage
1748121 Members
3349 Online
108758 Solutions
New Discussion

Re: Autoloader - 1/8 G2 Tape

 
SOLVED
Go to solution
Paulo_Louro
Occasional Visitor

Autoloader - 1/8 G2 Tape

Good Morning,

 

 

I am trying to update the firmware of my autoloader, but I am having dificulties finding the firmware in the HP site.

 

I put the serial number it goes to my autoloader but asks for a operating system, if i'm going to update via Autoloader WEB GUI, is it relevant the operating system? bit confused here, any help would be apreciated.

 

Here's the specs of my autoloader:

 

Autoloader Information Serial Number MXA74200GU Product ID 1x8 G2 AUTOLDR Currently Installed Autoloader Firmware 1.80 / 1.80n Bootcode Firmware Revision 0.60

 

Drive Specs:

Drive Information (LUN) Vendor ID HP Product ID Ultrium 3-SCSI Serial Number HUE08316P4 Firmware Revision D24W

 

It is connected via SCSI to a centos 7 server.

 

Thank you

1 REPLY 1
Torsten.
Acclaimed Contributor
Solution

Re: Autoloader - 1/8 G2 Tape

Get the bundle

 

http://h20564.www2.hpe.com/hpsc/swd/public/detail?sp4ts.oid=5111607&swItemId=co_146926_1&swEnvOid=4064#tab2

 

and use the web GUI to update.

 

Read the notes about the steps!!!

 

 

Drive FW is still the same, loader firmware should be 4.30 finally.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!