HPE Community
StoreEver Tape Storage
1752802 Members
5003 Online
108789 Solutions
New Discussion юеВ

Re: Command View TL for ESL712e

 
Suzi Fischman
Frequent Advisor

тАО11-25-2009 09:00 AM

тАО11-25-2009 09:00 AM

Command View TL for ESL712e

CVTL 2.5 build 110
firmware 7.00.60
interface manager I250
Interface Controller 5953

After a re-boot of the library I have to wait for 20-30 min before I see anything in Operations(Media Management) is this by design?

I have 14 lto3 tape drives and I am running CommVault Galaxy 7.0.
0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО11-25-2009 10:03 AM

тАО11-25-2009 10:03 AM

Re: Command View TL for ESL712e

Depending on the number of slots it takes a lot of time to do the inventory. After this is done, the library come online.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
Efrain Valencia
Valued Contributor

тАО11-30-2009 07:34 AM

тАО11-30-2009 07:34 AM

Re: Command View TL for ESL712e

A fully loaded library can take up to 45 minutes to initialize, if you have unlabeled media in it it may increase the time as well :)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.