StoreEver Tape Storage
1748185 Members
4537 Online
108759 Solutions
New Discussion юеВ

Re: device not getting detected

 
DPVamsi
Occasional Contributor

device not getting detected

Hi,
I have the device "HP StorageWorks LTO-4 Ultrium 1840 SCSI"

The server is RX2660 running HP-UX 11.31.

SCSI Ultra320 A6961-60111 is the card my server has. All the drivers for SCSI Ultra320 scsi card are installed.

The tape drive "HP StorageWorks LTO-4 Ultrium 1840 SCSI" is not getting detected. could you help me out in getting detected.

presently i have not installed LTT. if i install it how do i search for the device. are there any drivers that needs to be installed - If yes which drivers are needed.
if the drivers needs to be installed from LTT - how do i install them?

Regards
Praveen
2 REPLIES 2
Torsten.
Acclaimed Contributor

Re: device not getting detected

If not visible in ioscan, LTT can't see it either.


Please post

# ioscan -fn

first and check for bent pins!!!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Eblyn Solis
Honored Contributor

Re: device not getting detected

Hi,

Also check if on SAM the driver -> stape are on In in both,Current State and Pending State

Regards
Please assign a kudo to this post, if you find it useful.