HPE Community
StoreEver Tape Storage
1753840 Members
9579 Online
108806 Solutions
New Discussion юеВ

Re: MSL6000 - E1200 bridge

 
SOLVED
Go to solution
inex
Super Advisor

тАО12-16-2008 01:43 PM

тАО12-16-2008 01:43 PM

Re: MSL6000 - E1200 bridge

It helps a lot :-)
0 Kudos
Reply
inex
Super Advisor

тАО12-16-2008 02:05 PM

тАО12-16-2008 02:05 PM

Re: MSL6000 - E1200 bridge

What does this warning from the fw release notes means?
I have an MSL6000 with E1200-160 and LTO4

-inex


The 5.9.44 interface controller code should only be used with interface manager I232 and above (EML and ESL-e), and I182 (ESL9000). If you are using interface manager code between I200 and I231 then you will need to upgrade to I232 in order to use 5.9.44. Failure to perform the interface manager upgrade may result in an issue where hosts recently added to the SAN do not appear in the Command View TL (CVTL) list of known hosts even after clicking on the "Refresh" button in the "Add Known Host/HBA" dialog".
0 Kudos
Reply
Torsten.
Acclaimed Contributor

тАО12-16-2008 10:18 PM

тАО12-16-2008 10:18 PM

Re: MSL6000 - E1200 bridge

You can ignore this - this is related to EML/ESLe series libraries - they use the same NSR, but management is different.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
inex
Super Advisor

тАО12-17-2008 08:43 AM

тАО12-17-2008 08:43 AM

Re: MSL6000 - E1200 bridge

Thanks for your help.

-inex
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.