HPE Community
StoreEver Tape Storage
1752565 Members
4916 Online
108788 Solutions
New Discussion юеВ

Re: msl6060 and NSR

 
SOLVED
Go to solution
glennn
Advisor

тАО09-10-2009 01:34 AM

тАО09-10-2009 01:34 AM

msl6060 and NSR

Hi.

We have an MSL6060. the 2 NSR ports have been connected to the san switches and i'm able to see it's wwn anf perform zoning. But when i check the server where i zoned it to, it can't see any tape drives. I'm new to NSRs. Did i miss something? Is there something that has to be configured in NSR?

thanks very much!
0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО09-10-2009 01:52 AM

тАО09-10-2009 01:52 AM

Solution

Re: msl6060 and NSR

You need to configure a mapping on NSR (what server is allowed to see which device). Point your browser to the NSR.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
glennn
Advisor

тАО09-10-2009 01:56 AM

тАО09-10-2009 01:56 AM

Re: msl6060 and NSR

Thanks Torsten! Will check this out.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.