1748224 Members
4391 Online
108759 Solutions
New Discussion юеВ

MSL6060fc drivers

 
Adel Elamin
Frequent Advisor

MSL6060fc drivers

Dear ITRC memeber
I have HP MSL6060 2 LTO-4 Ultrium 1840 Drive 4Gb FC Library (AJ032A)connected to our Backup server DL360G7 with Qlogic 82Q PCI-e FC HBA Dual Port, through 8/24 SAN switch and my problem is that my server can not detect my MSL6060.
I have data protector V6.11 as well installed in the Backup server under Windows 2008R2 Enterprise edition.
I wonder it there are any drivers to setup the library or something els?
please advice?
Thanks in advance.

Regards
Adil
6 REPLIES 6
Adel Elamin
Frequent Advisor

Re: MSL6060fc drivers

Dear All
I have accessed HP StorageWorks e1200-320 4G Interface Controller through web interface and I tried to discover fc port 0 (which is connected directly to my server), however nothing have been discovered.

but whenever I connect the library to SAN switch fc port can detect only my EVA HSV300

please see the attachment and advice
thanks in advance
Jethesh
Valued Contributor

Re: MSL6060fc drivers

Hi Adel,

the setup should be as follows.
1)connect TL to SAN switch
2)Connect backup Server to SAn switch
3)Create a Zone between server and TL NSR.
4)Go to NSL Web interface and create mapping of WWN for backup Server.

let us know if you need any more clarifications on the same.
Torsten.
Acclaimed Contributor

Re: MSL6060fc drivers

You need to discover devices on the SCSI channel, not on the FC port.

Create a map!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Adel Elamin
Frequent Advisor

Re: MSL6060fc drivers

Hi Jethesh!

I am going to follow your steps and feed u back after 2 hours from now.

Hi Torsten!

whenever I discover devices on the SCSI channel, it detect my MSL6060 tape library and 4 HP Ultrium 1840 tape drives, but I have never tried to create map for them, I'm going to try them after 2 hours from now and feed you back.

Many thanks all
Adel Elamin
Frequent Advisor

Re: MSL6060fc drivers

Dear All;

Greeting

I did follow Jethesh, and Torsten steps

I have created a zone contain a backup and MSL in the SAN switch, then I did Mapping on the MSL, after that MSL appeared in my backup servers

Many thanks again

:-)
Jethesh
Valued Contributor

Re: MSL6060fc drivers

Please assign points for those who spend time to help you. :-)