HPE Community
StoreEver Tape Storage
1753591 Members
6219 Online
108796 Solutions
New Discussion юеВ

taperobot upgrade

 
Ole Martin Aas
Valued Contributor

тАО04-23-2008 04:45 AM

тАО04-23-2008 04:45 AM

taperobot upgrade

Hi there

I'm going to upgrade an MSL6030 and the NSR e1200-160 and i'm unsure if the NSR-upgrade can be done from the LTT-utility .
It looks like a possible way of doing it would be to run the robot and drive updates from the LTT and use the ftp interface on the NSR for that upgrade and should it be done in any specific order ?
hope to have some advice on this

regards
Ole Martin Aas
0 Kudos
3 REPLIES 3
Torsten.
Acclaimed Contributor

тАО04-23-2008 05:01 AM

тАО04-23-2008 05:01 AM

Re: taperobot upgrade

If the NSR is visible to the outside world (keyword NSR mapping) LTT can do this.

But I did this many times with FTP without problems (different firmware file format!) - make sure to save a copy of the config!

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Ole Martin Aas
Valued Contributor

тАО04-29-2008 02:40 AM

тАО04-29-2008 02:40 AM

Re: taperobot upgrade

Hi
Thanks for the info - I think i'll use ftp for the NSR as i'm familiar with that

regards
Ole Martin Aas
0 Kudos
Ole Martin Aas
Valued Contributor

тАО04-29-2008 02:41 AM

тАО04-29-2008 02:41 AM

Re: taperobot upgrade

closing
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.