StoreEver Tape Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Ultrium 232 Tape LED blinking

 
SOLVED
Go to solution
Highlighted
New Member

Ultrium 232 Tape LED blinking

Our tape drive tries to mount the tape several times after inserting one. The tape then ejects and the tape LED starts blinking. I've powered the drive off overnight, tried two different tapes, and also restarted the driver using devcon with the same result. I have attached a L&TT support ticket. Please help. Thanks
4 REPLIES 4
Highlighted
Honored Contributor
Solution

Re: Ultrium 232 Tape LED blinking

There is evidence of an error while loading the tape.
Try to disconnect the cable from the LTO, check from the front panel if there is dust or something inside that is damaged or if the sensors are full of dust, then try to load a new cartridge with the scsi cable disconnected from the host, and see if you can do it.
If this do not work, I think you will have to replace your unit
Highlighted
Valued Contributor

Re: Ultrium 232 Tape LED blinking

Yes, Do make sure the Firmware is up2date because we have seen these issues getting resolved with the Firmware update also.

If its a Leader issue, then you may have to get the Tape Drive replaced.
Highlighted
Honored Contributor

Re: Ultrium 232 Tape LED blinking

start LTT, when the scan is finished, go in the top bar and select File> get files from web, and you will be able to get from internet the latest fw for your drive.

once this is downloaded in your host, then select the drive and select the big button with Firmware and you will be able to updtae the drive
Highlighted
New Member

Re: Ultrium 232 Tape LED blinking

The tape drive is operating normally again. I disconnected the drive completely and inspected it for dust and thought it looked clean. I used some compressed air at a medium gentle pressure anyway to be certain it was dust free. I then connected the power and inserted a tape succussfully. I then ejected the tape, powered down, reconnnected scsi cable, got latest firmware and found that it was the same version already installed. I updated the firmare to the downloaded one anyway, then confirmed the tape still was being accepted successfully. Thank you for your prompt responses.