RAID REPAIR STROVIRTUAL 4000

[testmado662]

Hello,

I found a post on this forum about RAID Repair. The prodedure was posted and it's necessary to admin connect in order to put node into repair mode. https://support.hpe.com/hpesc/public/docDisplay?docId=mmr_kc-0112618

Since new LeftHand versions, we can't conect to admin. Can we do it over CMC or only HPE technicals can do it ?

Thanks for your help.

[Mahesh202 · Accepted solution]

Hi

Thank you for coming on HPE Community Forums.

I went through the link which was shared and, I suggest you to try with the same as it is mentioned in the link.

https://support.hpe.com/hpesc/public/docDisplay?docId=mmr_kc-0112618

If you have any further clarifications, I would suggest you to get in touch with the HPE Technical Support to get this resolved.

Hope this helps.!

Regards
Mahesh202

[MOHINK]

Hello  testmado662 .

We need  adminstrator login to place the Node in repair.

If the store is working fine, the node will not go into repair mode from CMC, we need to stop the dbd_store service to force the repair from CLIQ.

Putty into the Node with poert 16022 , you can use CMC login credentials  and ran utility run="servicectl dbd_store stop".

Then from CMC ->r right click on the node, select repair storage system

You can contact HPE support.

Regards

MOHINK

[testmado662]

hello,

Thatnks for the procedure. I think we forget login to node in order to stop Processes.

Regards

[testmado662]

hello Mohink,

We can connect as SAN Admin, we don't need to use an HPE root user ?

I know that some operation are only authorized for HPE support.

If our current admin user works, no problem to repair RAID 5.

Regards

[MOHINK]

SAN Admin credentials will work for the operation suggested

[testmado662]

Hello,

We did RAID repair and works correctly. No more errors on that node.

Thanks for your help