HPE Community
Switches, Hubs, and Modems
1753481 Members
4164 Online
108794 Solutions
New Discussion

Re: Enable 10GE on a Procurve 2910 al switch

 
4neti
Occasional Contributor

‎11-29-2011 04:33 AM

‎11-29-2011 04:33 AM

Enable 10GE on a Procurve 2910 al switch

Hi

 

I have a 2910 al 24G switch and is trying to enable the two 10GE SFP+ modules at the back of the switch. How do i do that?

 

When i go to Configuration ----> Device view the back panel is greyed out

 

Is there some special way to enable the 10GBE back ports?

 

Thanks

0 Kudos
1 REPLY 1
xpa
Occasional Advisor

‎12-10-2011 02:56 PM

‎12-10-2011 02:56 PM

Re: Enable 10GE on a Procurve 2910 al switch

It´s full automatic

 

just mount the modules, connect a GORE cable between them and link led lights on and here you have 2 procurve 2910al connected at 10GB.

 

  

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.