HPE Community
Switches, Hubs, and Modems
1753518 Members
5067 Online
108795 Solutions
New Discussion

Re: HP switch 1920 - JG923A - find IP on specific Port

 
grenzo
Frequent Advisor

‎08-31-2020 08:40 AM

‎08-31-2020 08:40 AM

HP switch 1920 - JG923A - find IP on specific Port

Hi,

i have an HP switch 1920-16g JG923A , i would like to know if there is any CLI command to display IP of the connected device on a specific port.

thank you.

0 Kudos
1 REPLY 1
Ivan_B
HPE Pro

‎08-31-2020 08:44 AM

‎08-31-2020 08:44 AM

Re: HP switch 1920 - JG923A - find IP on specific Port

Hi @grenzo !

If Vlan-interfaces of the switch are default gateways for hosts in respective VLANs, e.g. if you use this switch as a router, then "display arp" should do the job. If you use the switch as L2 switch, I don't think it is possible, simply because in this case it doesn't care about IP addresses.

Hope this helps!

 

I am an HPE employee

Accept or Kudo

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.