HPE Community
Switches, Hubs, and Modems
1753787 Members
7177 Online
108799 Solutions
New Discussion

Hp Switch 2910al Excessive CRC errors

 
jwc1972
Advisor

‎08-17-2011 01:11 AM

‎08-17-2011 01:11 AM

Hp Switch 2910al Excessive CRC errors

Hello

 

We have a managed swicthed we are seeing Excessive CRC Aligment errors on the status page on one port. On the port Counters we are getting Errors RX. On the Port status is set to Auto its showing as 100FDx as UP. Is probelm with the switch or the network device.   The network device is a network camera.

0 Kudos
1 REPLY 1
Oleg Sukharev
Valued Contributor

‎08-26-2011 07:44 AM

‎08-26-2011 07:44 AM

Re: Hp Switch 2910al Excessive CRC errors

Hi jwc1972

The cause can be misconfiguration of port speeds on camera and switch (camera didn't agree and chose 100HDx), or problems with cable (too long, problems with connectors).

HTH
Oleg
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.