J4903A ProCurve Switch 2824

[Németh Márk]

We use an J4903A ProCurve Switch 2824.
I connect to it with telnet.
If I write "show snmp-server" it writes this:
"

Community Name MIB View Write Access
---------------- -------- ------------
public Manager Unrestricted
private Manager Restricted

Trap Receivers

Link-Change Traps Enabled on Ports [All] : All

Send Authentication Traps [No] : No

Address Community Events Sent in Trap
---------------------- ---------------- -------------------"
If I tell him "snmp-server", it writes:
"Invalid input: snmp-server"
What is the problem?

And where can I find "hpswitchauth.mib"?

[Richard Brodie_1]

If I tell him "snmp-server", it writes:
"Invalid input: snmp-server"

You aren't in config mode.

And where can I find "hpswitchauth.mib"?
http://www.hp.com/rnd/software/MIBs.htm

[Németh Márk]

Yes, I also discovered. I must write "configure" and I must hit enter and voilá! :)))

I also found that link, but there is a lot of universal mibs. I thougth there is a special mib for this device.

I worked also with Moxa switches. There were special mib for that switchtype and it contains only OIDs ans traps, what the switch "knows".