procurve switch 1800 SNMP MIB

[Hiro321]

I am seeking L2 switches that support SNMP.

I read the overview page of ProCurve Switch 1800 and find out this switch supports SNMP(Read only).

However,It isn't specified what kind of MIB does it support.

I want to know which SNMP manager can get each port status(Link up or down) on the switch or not.

[Javed Padinhakara · Accepted solution]

To know the current operating status of each port, you can query the MIB ifTable - specifically look for 'ifOperStatus' [iso(1).org(3).dod(6).internet(1).mgmt(2).mib-2(1).interfaces(2).ifTable(2).ifEntry(1).ifOperStatus(8)] entries in this table.

1800 supports the standard MIB's and some HP specific MIB's. To get complete list of MIB's, check out
http://www.hp.com/rnd/software/mibs-mar08.htm

Let know if that helped?
Javed

[Hiro321]

This is what I want to know.

I think I will buy this type of switch.

It was the first time to post a message to this forum.
I had been worried about response.
Now,I'm so glad.

Thank you for all the information you gave me.

[Javed Padinhakara]

I am glad to know the info helped influence your decision to buy ProCurve switch.

Happy days ahead :-)

Since this is your first post to the forum, thought will share w/ you some etiquettes followed in this Forum, including how you can show appreciation by assigning points ;-)

Here it is : http://forums11.itrc.hp.com/service/forums/helptips.do?#34

Wish you great days ahead with ProCurve.

Cheers
Javed

[Javed Padinhakara]

Here is one:

"ITRC Forum Etiquette"

http://66.34.90.71/ITRCForumsEtiquette/after.html