Set Date and time in HP Procurve Switch

[shootingstar29]

How to set date and time HP Procure 2810 Switch.
I have managed to set the time but not the date.

What CLI command should I type?

[EckerA]

Hi,

sw1-test-lab-35c(config)# time
begin-date The begin date of daylight savings time
MM/DD[/[YY]YY] New date <----------
daylight-time-rule The daylight savings time rule for your location
end-date The end date of daylight savings time
HH:MM[:SS] New time <----------
timezone The number of minutes your location is West(-) or
East(+) of GMT

sw1-test-lab-35c(config)# time

[Tijl van der Steeg]

Als makes sense to configure (s)ntp

"SNTP Server 1.1.1.1"

[Shadow13]

use the command as this.
#time month/day/year hr:min:sec
#time timezone
#time daylight-time-rule
you can use the ? after every command to check the options

where is the difference between the local time zone and GMT.

And if you have SNTP server you can use these commands below:

#time sync sntp
#sntp server
#sntp unicast
#sntp here you define the interval

To show the current time.
#show time


Regards,