HPE Community
Operating System - HP-UX
1753523 Members
6753 Online
108795 Solutions
New Discussion

Npar mode from vpar mode

 
sagar24
Occasional Contributor

‎08-29-2011 04:51 AM

‎08-29-2011 04:51 AM

Npar mode from vpar mode

Hi

 

if I need to boot in nPar mode from a vpar.

I see that I need to run vparenc -m npars command to set  the npar mode and then reboot.

 

Is it similar to reboot and at the EFI prompt do boot vmunix  in staed of boot vpmon.

 

Sagar

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎08-29-2011 05:27 AM

‎08-29-2011 05:27 AM

Re: Npar mode from vpar mode

A simple reboot is not enough on Integrity systems.

 

You need to switch the mode (this toggles the mode in firmware), then reboot to vmunix.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.