cancel
Showing results for 
Search instead for 
Did you mean: 

RAID-1 on ProLiant ML110 G5

 
Highlighted
New Member

RAID-1 on ProLiant ML110 G5

Hi, i would an information.

I've installed SLES11 and I've created an array into the BIOS HP CONFIGURATION UTILITY.
How I monitor if the RAID-1 really work?
8 REPLIES 8
Highlighted
Honored Contributor

Re: RAID-1 on ProLiant ML110 G5

Highlighted
New Member

Re: RAID-1 on ProLiant ML110 G5

Ok thank. I try this.
Highlighted
Honored Contributor

Re: RAID-1 on ProLiant ML110 G5

IF your using the embedded SATA RAID controller it does not appear that a driver disk has been released for SLES11. You need the aarachi driver which does not ship with any distribution as it is a closed source driver. The RAID function of the embedded controller is software based and needs the driver.
No support by private messages. Please ask the forum! 
Highlighted
New Member

Re: RAID-1 on ProLiant ML110 G5

I didn't install any driver on SLES11 and it seems work.

If i detach an HDD, system start and work normally.

At the reboot the BIOS alert me that di ARRAY is DEGRADED, thus i rebuilt it.
Highlighted
Honored Contributor

Re: RAID-1 on ProLiant ML110 G5

test
Highlighted
New Member

Re: RAID-1 on ProLiant ML110 G5

I test it detach before the firs HDD on port#0 e then the HDD on port#1, and in both case the system work and SLES11 run normally.
Highlighted
Honored Contributor

Re: RAID-1 on ProLiant ML110 G5

hi,

in my opinion, i will use SW raid on Linux level instead of the MB board.


mikap
Highlighted
New Member

Re: RAID-1 on ProLiant ML110 G5

Thanks for reply.

Another question:

Is important activate the write cache?
If the answer is yes, why?

Thanks

Sorry for my bad english.