RX6600 basics

[S. Ney]

Try sasmgr -N get_info -D /dev/sasd1 -q raid instead. I've also attached a guide for you. chapter 4 has some useful commands. I have a couple of rx6600's on 11v3 as well and the sasmgr commands have come in handy. You can add disks later with sasmgr from the command line.

[rjpierson]

Thanks for that, I'm looking at the stack of optical disks that came with these machines and wondering where to find the time to dig into them. Got lucky I have open office installed too.
ren2:/ # sasmgr -N get_info -D /dev/sasd1 -q raid
Thu Sep 16 15:32:50 2010

---------- LOGICAL DRIVE 7 ----------

Raid Level : RAID 1
Volume sas address : 0x3a18a0412b8a2ca
Device Special File : /dev/rdisk/disk1
Raid State : OPTIMAL
Raid Status Flag : ENABLED
Raid Size : 139898
Rebuild Rate : 0.00 %
Rebuild Progress : 100.00 %

Participating Physical Drive(s) :

SAS Address Enc Bay Size(MB) Type State

0x5000c50023a9d991 1 1 140014 SECONDARY ONLINE
0x5000c50023a969d1 1 2 140014 PRIMARY ONLINE