1950 data voice vlan

[raj567]

how to configure data and voice vlan in same port of 1950 HP switch

[akg7]

Hi,

Try to setup port to trunk or hybrid and tagged the voice vlan and the data vlan should be untagged.
Also enable lldp or cdp as per the requirement.

Thanks!

[akg7 · Accepted solution]

Hello @raj567 ,

Has my post helped you to answer your query?

Thanks!

[raj567]

Hi

when I enter in to CLI Mode,I am getting <hp>.

unable to enter configuration mode.can you please tell how to enter config t or configuration mode.

RAJESH

[raj567]

Hi

when I enter in to CLI Mode,I am getting <hp>.

unable to enter configuration mode.can you please tell how to enter config t or con

[akg7]

2. Now go to Network->Interfaces and select interface which you want to configure for both. 

Follow the same as per the screenshots.

3.  Network->Links->LLDP and follow the settings for the selected interface as below:

I hope this will help you.

Thanks!

[raj567]

hi

thanks a lot.

hope vlan 2 is voice Lan and it should be tagged anf vlan 3 is data vlan and it should be untagged..

what is Qos setup to be done.

And also I am doing etherchannel from This L2 Switch( two Links from port 23 and 24) to 2 L3 Switch 2930f ( stacked L3 Switch ). access ports.

just if i make etehr-chgroup and give identication no is enough.

Rajesh

[raj567]

hi

i did the way you guided me.still my IP phones not getting mac address.

I should add UID to switch.pls confirm

Thanks in advance

Rajesh

[akg7]

Hi,

You can add UID.

Also share the screenshots.

Thanks!