HPE Community
Web and Unmanaged
1753560 Members
5534 Online
108796 Solutions
New Discussion

LACP on 1810G 24 Port Switch

 
Eric F Crist
New Member

‎03-05-2010 11:12 AM - last edited on ‎12-25-2013 07:34 PM by

‎03-05-2010 11:12 AM - last edited on ‎12-25-2013 07:34 PM by

LACP on 1810G 24 Port Switch

I have a problem getting more than 926Mb/s on a four port LACP to a FreeBSD box over gigabit ethernet with cat-6 wiring.

Both the FreeBSD ifconfig output and web interface for the switch indicate all four ports are active, however.

Any ideas on what I may be missing?

 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Web and Unmanaged. -HP Forum Moderator

0 Kudos
1 REPLY 1
Richard Brodie_1
Honored Contributor

‎03-05-2010 12:20 PM

‎03-05-2010 12:20 PM

Re: LACP on 1810G 24 Port Switch

You have to be careful about load balancing with LACP. I think the Procurves hash source/address destination address pairs.

If you were load testing from (say) a single 10Gb port on other system, that would explain it.

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.