RAID configuration

[sawserland]

Hello,
I have a proliant hp DL20 Gen10 server. When I want to configure my disks or my raids I receive the following message "No device found"
Can you show me how to configure raids or create logical drives on the hp proliant DL20 Gen10?
My server has two 1 TB sata hard drives each
Thank you

[Harsh_b]

Hello sawserland, 

May i know which raid controller is used for raid configuration ? is there any add on controller or embedded HPE Smart Array S100i SR Gen10 SW RAID
Please Note 
− HPE Smart Array S100i SR Gen10 SW RAID will operate in UEFI mode only. For legacy support an additional controller will
be needed,

HPE Smart Array S100i SR Gen10 SW RAID is off by default and must be enabled by selecting 784308-B21.
− The S100i is a 14-port SATA controller, but only 12 ports are accessible as 2 are leveraged to support the 2 M.2 options on
the Primary Riser.
− The S100i supports windows only

Does that drive led illuminates / blinks during power on server ? if yes ensure that SAS cable connection is ok and seated properly from disk backplane to controller. 

Let us know if above actions helpes to fix the issue, 

Cheers

Regards 

[Harsh_b]

Hello sawserland, 

Please do let us know if reported issue is fixed now or you need additional help on same,  

Regards

[Harsh_b]

Hello @sawserland , 

Please do let us know if you were able to complete the installation.

Regards