Posted to: HPE Alletra Storage
51m ago Its not surprising that customers might with to virtualize their file services, as it seems that the assumptionfor near all services is to virtualize first and only utilize bare hardware for extreme situations.The question becomes is File Services en...
Posted to: HPE Nimble Storage Solution Specialists
an hour ago Got an alert last night for HP Nimble HF20H-2OBT-11T-960F stating system health check failures were found. Resolve failures before attempting failover. Noticed array 1 shows none. Any way to get array 1 back online? Posted to: Apollo
3 hours ago HiI'm kinda assuming the Apollo forum is the best place for Alletra 4140 questions? If not then appologies.I was curious if there is any special power cabling requirements for the Alletra 4140 PSU? There are FOUR psu's in the back of the Alletra 414... Posted to: HPE SimpliVity
7 hours ago Hello everyone,I would like to clarify a question regarding the HPE SimpliVity Arbiter version alignment during an upgrade path.I was asked to upgrade an environment from HPE SimpliVity 4.1.3 to 5.3.1.Following the documentation and Simplivity Upgrad... Posted to: HPE SimpliVity
Monday Hey all, So far I found no posts regarding my issue so I will start a new one:TL:DRI try to migrate VMs from VMware to HVE for SVT. I know officially there is no support for that yet (which i do not understand).However the migration data transfer has... Posted to: HPE Primera Storage
a week ago The current version of HPE Permera 600 is 4.2.6. After replacing the PCBM faulty part, the issue persists, triggering ISSUE ID:309228, a known bug for C24963. Now, the plan is to first update online to 4.2.8+PK, and then update to 4.4.1. However, dur... Posted to: HPE Alletra Storage
a week ago Hi all, I would like to ask about an issue where the Replication Partner System is showing “Unknown” on our HPE Alletra MP storage. Previously, the DR site displayed a normal green status, and the Production site still shows normal. However, the DR s... Posted to: HPE 3PAR StoreServ Storage
Friday Hello Everyone.This is 555-denoh.An end user shut down a 3PAR 7200 in response to a power outage in their building.The end user then powered on the 3PAR 7200. However, the 3PAR 7200 did not boot.1. Insplore LogTPD undergoing upgrade. Safe mode enable... Posted to: Servers - General
a week ago I've got a 12lff DL380 gen9, it's full and the drives are controlled by the add-in pcie card.I've seen there is a 2sff rear bay kit (724864-B21) which I assume plugs into the motherboard controller.But I have seen a set of cables (826011-001) for the...
Posted to: ProLiant Servers (ML,DL,SL)
09-18-2025 There is a issue again,. I have been following up this issue since v3.08 and indeed this was resolved in v3.10 & again I see this has started since v3.15 latest upgrade. I upgraded SPP release and even BIOS to U v3.60 but nothing helps and smad crash...
