HPE Community
Operating System - HP-UX
1832970 Members
3747 Online
110048 Solutions
New Discussion

Monconfig x SAM EMS

 
LucianoCarvalho
Respected Contributor

‎05-28-2003 03:41 AM

‎05-28-2003 03:41 AM

Monconfig x SAM EMS

Hi Guys!

Could somemone tell me the difference between the configuration created through monconfig and the configuration created through sam ems gui?
I created some monitoring request through SAM but when I enter monconfig and list the monitors configured, the ones I configured trhough SAM are not listed.
The same happens on SAM, that is, it doesn't show the monitors configured through monconfig.
thanks in advance.
0 Kudos
Reply
2 REPLIES 2
Tom Geudens
Honored Contributor

‎05-28-2003 05:06 AM

‎05-28-2003 05:06 AM

Re: Monconfig x SAM EMS

Hi,
I believe http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0xa4e035067c18d6118ff40090279cd0f9,00.html explains this.
My search was "EMS monconfig SAM".

Regards,
Tom
A life ? Cool ! Where can I download one of those from ?
0 Kudos
Reply
Fabrice Pouchot
New Member

‎05-28-2003 05:29 AM

‎05-28-2003 05:29 AM

Re: Monconfig x SAM EMS

Hello,

Quickly ...
With monconfig, you monitor hardware resources.
And with SAM, you monitor 'software' resources.

Fabrice
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.