my cimserver is not starting... and I don't know why.
I put "set -x" near the top of the start up script and get:
/sbin/rc2.d# ./S600cimserver start
+ rval=0
+ [ -f /etc/rc.config.d/cimserver ]
+ . /etc/rc.config.d/cimserver
+ CIMSERVER=1
+ [ 1 -eq 1 -a -x /opt/wbem/sbin/cimserver ]
+ + ps -e
+ grep cimserver$
+ 2>& 1
junk=
+ [ 1 -ne 0 ]
+ + /opt/wbem/sbin/gen_wbem_certs -verify
+ 2>& 1
junk=Certificate verification: Success
+ [ 0 -ne 0 ]
+ /opt/wbem/sbin/cimserver
PGS10033: The CIM Server is not started: PG_ProviderModule
+ set_return
ERROR CODE 1
+ exit 1
===============
/sbin/rc2.d# /opt/wbem/sbin/gen_wbem_certs -verify
Certificate verification: Success
==============
/opt/wbem/sbin/cimserver
PGS10033: The CIM Server is not started: PG_ProviderModule
==============
I just installed the Sept 2010 patches...
FEATURE11i B.11.31.1009.353a Feature Enablement Patches for HP-UX 11i v3, September 2010
HWEnable11i B.11.31.1009.353a Hardware Enablement Patches for HP-UX 11i v3, September 2010
QPKAPPS B.11.31.1009.353a Applications Patches for HP-UX 11i v3, September 2010
QPKBASE B.11.31.1009.353a Base Quality Pack Bundle for HP-UX 11i v3, September 2010
==================
Any ideas anyone?
Thanks
