Community
3PAR StoreServ Storage
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

how 3par performs node failover in a 2-node system ?

 
bayern0906
bayern0906
Occasional Contributor

‎02-07-2018 08:45 PM

‎02-07-2018 08:45 PM

how 3par performs node failover in a 2-node system ?

Hi guys

Anyone knows how auto cutover operates when one of the nodes fail in a 2-node 8440 system?

How does the remaining node know that the partner node has failed ? 

 

For example, in a NetApp 2-node system, each node are connecting to each other along with mailbox.

So if one node down,  but the drives are fine, then the remaining node knows that the partner has down and performs a takeover

0 Kudos
Reply
1 REPLY
Sheldon Smith
Sheldon Smith
Honored Contributor

‎02-08-2018 12:13 PM

‎02-08-2018 12:13 PM

Re: how 3par performs node failover in a 2-node system ?

Two or four controller nodes: Tightly clustered, with a full-mesh controller backplane.

See the HPE 3PAR StoreServ Architecture whitepaper - 4AA3-3516ENW


Note: While I work for Hewlett Packard Enterprise, all of my comments (whether noted or not), are my own and are not any official representation of the company.
----------
If my post was useful, click on my KUDOS! thumb below!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.