Midrange and Enterprise Storage
Midrange and Enterprise Storage
Find answers to your questions about HPE Midrange and Enterprise Data Storage products and solutions in this forum.
1847826 Members
4814 Online
104021 Solutions
New Discussion

Join the conversation with experts and colleagues

Posted to:
Original author:
Front End Network: Your first consideration is the connectivity from the clients to the SMB shares, ideally you should have a pair of high speed interfaces for each node. These interfaces will have load balancing set to ensure that they both load equ...
Posted to:
Original author:
Its time to consider the consumers of the file services. These consumers have needs, and the needs are based on the type of OS and the version of the OS, in the form of expected behavior. By default Windows Server will attempt to use the highest supp...
Posted to:
Original author:
Its not surprising that customers might with to virtualize their file services, as it seems that the assumption for near all services is to virtualize first and only utilize bare hardware for extreme situations. The question becomes is File Services...
Posted to:
Original author:
Hi What are the rules behind configuring async replication relationships between new and old Nimbles? I have some data on an old CS300 that I would like to replicate to an Alletra 5k. The old CS300 are running firmware version 5.x and the Alletra 6.x...
Posted to:
Original author:
Hello Everyone. This is 555-denoh. An end user shut down a 3PAR 7200 in response to a power outage in their building. The end user then powered on the 3PAR 7200. However, the 3PAR 7200 did not boot. 1. Insplore Log TPD undergoing upgrade. Safe mode e...
Posted to:
Original author:
Hello Everyone, Please tell me the procedure for 3PAR 20480 Node Rescue. After replacing the target node, pause POST with Control+W and check with Whack> prom edit. Also check the value of "System Serial: 0." If it is not 0, run "Wh...
Posted to:
Original author:
Everyone, please support us. I found a 3PAR7200 in company supplies. The configuration is as follows. ・7200 Chassis ・Slot1 Node 3PAR OS 3.2.1.46 ・Slot0 empty ・Service Processor 4.x ・PCM x2 ・HDD x6 I purchased an additional 7200Nodes. 3PAR OS 3.2.2.70...
Posted to:
Original author:
https://www.dropbox.com/s/do8sgmnepmxxeym/3PAR_Management_Console_4.7.3_QR482-11188.iso?dl=0 Check if this is still valid
Posted to:
Original author:
Hi this is the procedure I have RemovePD Step Command Purpose 1 setpd ldalloc off <DiskID> To stop data to drive - Repeat for all PDs 2 showpd -s Make sure disks are in Degraded state 3 movepdtospare -f -vacate -nowait <DiskID> Vacate all...
  • Legend
  • New MessagesNew Messages
  • No New Messages No New Messages
  • Hot TopicHot Topic
  • Replied-to Thread Replied-to Topic
  • Read Only ThreadRead-Only Topic