HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Array Setup and Networking
cancel
Showing results for 
Search instead for 
Did you mean: 

rename group and array

 
SOLVED
Go to solution
mobo24
Occasional Visitor

rename group and array

I found the post about renaming array but just want to be completely sure it still applies

im unhappy with that my group is named group1 and array is nimbleh1 so i would like to rename both

any disruptions to services if i change both ?

we only got one cs300 array in the group

2 REPLIES
ndyer39
HPE Pro
Solution

Re: rename group and array

Hello Morten,

There's no problems in renaming an array within the group - as all of your data services are taken from the group level.

Renaming the group may cause any array based replication to fail, as replication partnerships are performed at the group level. This is the warning message you'll receive when you attempt to rename the group. Also note that any GUI certificates will also need to be refreshed.

Screen Shot 2017-01-26 at 12.20.13.png

mobo24
Occasional Visitor

Re: rename group and array

Thank you , i will give it a go