Aruba & ProVision-based

Telnet command

 
Earplugg
New Member

Telnet command

Hi

I want to use telnet to test services on the network from a Procurve switch. Is there a way to use telnet with a non standard port from the cli?

2 REPLIES 2
BGraham_1
Frequent Advisor

Re: Telnet command

If you are concerned about someone eavesdropping on your telnet session and/or username and password, I would suggest using ssh instead of telnet. It takes a little more set up on the switch and a seperate client (PuTTY), but is is a more secure remote cli access.

 

Bob

Helper
Valued Contributor

Re: Telnet command

hi,

 

It is not possible from the HP E-Series swtch. I have check the telnet command from a 3500yl switch with the latest firmware.

 

Bye.