HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Getting sensor information for the submitted sensor failed

 
Sreejith Kaliyam
Regular Advisor

Getting sensor information for the submitted sensor failed

am having a problem at the time of accessing the blade from RDP SERVER, SHOWING me the following error "Getting sensor information for the submitted sensor failed"showing the blade UNKNOWN. WILL YOU PLEASE REPLY THE SOLUTION ON THIS CASE
2 REPLIES
Dave Parker
Occasional Advisor

Re: Getting sensor information for the submitted sensor failed

I had the same problem on 2 bl685c's. I fixed it by going into the individual ilo's for the blades, selecting diagnostics and reset the the ilo.
Raghuarch
Honored Contributor

Re: Getting sensor information for the submitted sensor failed

Some times the blades ilo doesn't reply the Temperature sensor information back.
At that time you will see the "Getting sensor information for the submitted sensor failed"

Make sure the ilo is active. If the Ilo is active Try to go to the Temperature information page if the if there is data in the page then you should be able to access the server from RDP.

Otherwise reset the iLo it will fix the problem.