- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Help with Q in Q config
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
01-19-2021 03:03 AM
01-19-2021 03:03 AM
Help with Q in Q config
Hi there,
I am looking for a little bit of help regarding configuring Q in Q.
I am on the customer end not provider end. I have a QinQ dedicated vlan of 1112,
Does the below config look correct?
interface Bridge-Aggregation***
port link-type trunk
undo port trunk permit vlan 1
port trunk permit vlan 2 12 80 86 1112
port trunk pvid vlan 1112
qinq enable
link-aggregation mode dynamic
I look forward to hearing back from you guys,
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
01-19-2021 03:50 AM
01-19-2021 03:50 AM
Re: Help with Q in Q config
Hi @declan2777
The configuration looks good, but just wanted to know is there is any specific reason to use QinQ ? You need to add service tag where you exchange the QinQ vlan
For more inforamtion related to QinQ configuration ,i suggest you to refere below links.
https://support.hpe.com/hpesc/public/docDisplay?docId=emr_na-c03194012
I work for HPE

Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP